Sensors & Actuators: A. Physical

- Data for comparison of inductor performance for piezoelectric energy harvesting with synchronized switching architectures - Theoretical and experimental comparison of power harvested with synchronized electric charge extraction (SECE-based) methods

This data table is the specific data of the data graph in the paper. The corresponding data of the graph has been named accordingly.

These are research data related to the submitted paper "Contributions to the development of an axisymmetric SAW motor with a stator made from non-piezoelectric material" (Journal Sensors and Actuators A). A description of all shared files can be found in the file Measurement_and_Simulation_documentation.odt.

Extremum seeking control (ESC) is used to track the maximum efficiency of the rotary ultrasonic motor. Through ESC, driving frequency is controlled to minimize induced current. "ESC data" file presents the acquired data while tracking for different preloads and driving voltage amplitudes condition. The correspondence between maximum efficiency and minimum current is presented in "Optimum Efficiency Validation" file.

Supplementary material_Fitting formula

Fig 2b shows spectral response at different RIs of silica coating. Fig 4d illustrates transmission spectral responses of OMC before and after it was coated with mesoporous silica layer. Fig 6 shows transmission spectral responses and corresponding dip wavelength shifts at different temperature. Fig 7 shows the relation between wavelength shift and AMCs concentration at different temperature.

The attachment is the Raw data and simulation programs for this paper.

Measured resonance curves of the magnetoelectrically actuated double clamped beams with Wheatstone bridge configuration improving their sensitivity and resolution. Raw measurement data for the figures presented in the manuscript.

Matlab data file for 80km BOTDA system. A 300mw pump pulse with 20 ns is used. The frequency sweeps from10.88 GHz to 11.19 GHz with 1 MHz step and 512 averages per trace are used. A 5m hotspot placed at the end of the 80-km sensing fiber is produced by heating it up to 76 °C, while the rest of the sensing fiber has been maintained at ambient temperature (26°C). The FWHM of BGS is about 50Mhz.

The origin files of volume sensor results