Experimental data of the space ratio influence on the excitation frequencies of one and two cylinder free to vibrate in tandem arrangement
Description
Data result from careful measurements with accelerometers in an aerodynamic channel to study the influence of the space ratio on the flow-induced vibration of two cylinders in tandem arrangement with one or both cylinders free to vibrate. The aerodynamic channel is rectangular (0.193 X 0.146 m), with acrylic walls. A centrifugal blower of 0.75 kW impels the air through a diffuser, two honeycombs, and two screens. The turbulence intensity is 1% of the reference velocity, measured with a Pitot tube upstream of the test section. The Reynolds number ranged from 7100 to 24000, based on one cylinder diameter, and the reference velocity. The cylinders are smooth with 25mm diameter and L/D-ratios of 1.26, 1.4, 1.6, and 3.52. The cylinders free-to-vibrate in the transversal direction, are attached to two blades allowing the variation of length, to change the stiffness, as in Neumeister et al. (2021). The blockage ratio is 13.01 %. Nomenclature SC indicates a single cylinder (as reference). For tandem cylinders, FL means that the first cylinder is free to vibrate, for SL, the second cylinder, and BV both cylinders are free to vibrate. The cylinder acceleration is measured with accelerometers ADXL 335, data acquisition frequency, 1 kHz, low pass filter at 0.3 kHz. A 16bits A/D board NI USB-9162 was employed for the data acquisition. The mass-damping parameters were equal for the Cases 01 to 09: the mass ratio m*=608, the damping ratio ζ = 0.03, and the natural frequencies, fn1 = 7.8Hz and fn2 = 21.5 Hz. Cases 10 and 11 considered acceleration and flow velocity for m* = 539, ζ = 0.004 and the natural frequencies, fn1 = 8.8Hz and fn2 = 23.4 Hz. The cases with both cylinders had three configurations. First BV-configuration, Case 12: the first cylinder with a lower natural frequency than the second one. The parameters for the first cylinder were m* = 502, the damping ratio ζ = 0.003 and the natural frequencies are fn1 = 13.7Hz and fn2 = 36.2 Hz. For the second cylinder, m* = 547, ζ = 0.006 and the natural frequencies are fn1 = 24.4 Hz and fn2 = 71 Hz. Second BV-configuration, Case 13: the first cylinder with a higher natural frequency than the second. The parameters for the first cylinder were m* = 502, ζ = 0.002 and the natural frequencies are fn1 = 29.3 Hz and fn2 = 58.6 Hz. For the second cylinder, m* = 547, ζ = 0.009, and are fn1 = 10.7 Hz and fn2 = 30.3 Hz. Third BV-configuration, Case 14: both cylinders with the natural frequency in the same range. The parameters for the first cylinder were m* = 502, ζ = 0.008 and the natural frequencies fn1 = 10.8 Hz and fn2 = 22.5 Hz. For the second cylinder, m* = 547, ζ = 0.007 and the natural frequencies are fn1 = 10.7 Hz and fn2 = 31.2 Hz. Reference Neumeister, R. F., Petry, A. P., and Möller, S. V. 2021a). Experimental Flow-Induced Vibration Analysis of the Crossflow Past a Single Cylinder and Pairs of Cylinders in Tandem and Side-by-Side. Journal of Pressure Vessel Technology, v. 143(3), p. 031402.
Files
Steps to reproduce
The tested cases are organized into four folders, Series SC, FL, SL and BV, with sub-folders according to the L/D-ratio with files with results of time [s] and acceleration [m/s²] ordered by the reduced velocity Vr. The error of the signals: acceleration about 7%; velocity from 4% to 8%; frequency about 9%; reduced velocity, 10.5%. Data are in .txt format to be read by almost all software with time [s] and acceleration [ m/s²]. In Cases 10 and 11 (folders 1.26_1, both FL and SL), the data present time [s], acceleration [m/s²] and flow velocity [m/s]. 1-Series SC Case 01–Reynolds nr.: 1.2 x 104 to 2.4 x 104 SC_VR36.txt SC_VR49.txt SC_VR58.txt SC_VR62.txt 2- Series FL 1.26 Case 02–Reynolds nr.:1.2 x 104 to 2.4 x 104 FL_1.26_VR36.txt FL_1.26_VR49.txt FL_1.26_VR61.txt FL_1.26_VR72.txt 1.4 Case 04–Reynolds nr.:1.2 x 104 to 2.4 x 104 FL_1.4_VR37.txt FL_1.4_VR49.txt FL_1.4_VR61.txt FL_1.4_VR72.txt 1.6 Case 06–Reynolds nr.:1.2 x 104 to 2.4 x 104 FL_1.6_VR37.txt FL_1.6_VR48.txt FL_1.6_VR61.txt FL_1.6_VR72.txt 3.52 Case 08–Reynolds nr.: 1.2 x 104 to 2.4 x 104 FL_3.52_VR36.txt FL_3.52_VR48.txt FL_3.52_VR61.txt FL_3.52_VR71.txt 1.26-1 Case 10–Reynolds nr.: 1.2 x 104 to 2.3 x 104 FL_1.26_1_Vr32.5.txt FL_1.26_1_Vr37.4.txt FL_1.26_1_Vr43.7.txt FL_1.26_1_Vr49.5.txt FL_1.26_1_Vr50.1.txt FL_1.26_1_Vr54.1.txt FL_1.26_1_Vr58.5.txt FL_1.26_1_Vr62.1.txt FL_1.26_1_Vr63.7.txt 3- Series SL 1.26 Case 03–Reynolds nr.: 1.2 x 104 to 2.4 x 104 SL_1.26_VR37.txt SL_1.26_VR47.txt SL_1.26_VR61.txt SL_1.26_VR71.txt 1.4 Case 05–Reynolds nr.: 1.2 x 104 to 2.4 x 104 SL_1.4_VR48.txt SL_1.4_VR61.txt SL_1.4_VR72.txt 1. 6 Case 07–Reynolds nr.: 1.2 x 104 to 2.4 x 104 SL_1.6_VR48.txt SL_1.6_VR61.txt SL_1.6_VR72.txt 3.52 Case 09–Reynolds nr.: 2 x 104 to 2.4 x 104 SL_3.52_VR61.txt SL_3.52_VR71.txt 1.26-1 Case 11–Reynolds nr.: 1.2 x 104 to 2.3 x 104 SL_1.26_1_Vr32.6.txt SL_1.26_1_Vr39.txt SL_1.26_1_Vr43.9.txt SL_1.26_1_Vr47.7.txt SL_1.26_1_Vr50.txt SL_1.26_1_Vr52.9.txt SL_1.26_1_Vr55.6.txt SL_1.26_1_Vr59.3.txt SL_1.26_1_Vr64.7.txt 4- Series BV/ Config 1 Case 12–Reynolds nr.: 7.6 x 103 to 2.3 x 104 BV01_Vr13.6-C1_Vr7.6-C2.txt BV01_Vr17.5-C1_Vr9.8-C2.txt BV01_Vr21-C1_Vr12-C2.txt BV01_Vr27.9-C1_Vr15.6-C2.txt BV01_Vr30-C1_Vr16.7-C2.txt BV01_Vr31.8-C1_Vr17.8-C2.txt BV01_Vr34.2-C1_Vr19.2-C2.txt BV01_Vr36.9-C1_Vr20.6-C2.txt BV01_Vr38.6-C1_Vr21.6-C2.txt BV01_Vr41.6-C1_Vr23.3-C2.txt Config 2 Case 13–Reynolds nr.: 7.1 x 103 to 2.3 x 104 BV02_Vr5.8-C1_Vr16-C2.txt BV02_Vr8-C1_Vr22-C2.txt BV02_Vr9.6-C1_Vr26-C2.txt BV02_Vr10.8-C1_Vr29-C2.txt BV02_Vr12-C1_Vr33-C2.txt BV02_Vr12.8-C1_Vr35-C2.txt BV02_Vr14.9-C1_Vr40-C2.txt BV02_Vr16.5-C1_Vr45-C2.txt BV02_Vr18-C1_Vr49-C2.txt BV02_Vr19-C1_Vr51-C2.txt BV02_Vr19-C1_Vr52-C2.txt Config 3 Case 14–Reynolds nr.: 1.3 x 104 to 2.4 x 104 BV03_Vr28-C1_Vr28-C2.txt BV03_Vr35-C1_Vr35-C2.txt BV03_Vr41-C1_Vr41-C2.txt BV03_Vr46-C1_Vr46-C2.txt BV03_Vr52-C1_Vr53-C2.txt