Filamentproduction using DOE here Taguchi Method

Published: 22 February 2021| Version 1 | DOI: 10.17632/3w7g5fx65z.1
Sascha Hartig


This dataset was created when producing PLA filament using a 3devo filament extruder. One dataset is for pure PLA, one for recycled PLA out of crushed and tried old prints. As DOE method a Taguchi analysis was used. Mittels dieser Analogie konnten bessere Parameter setze gefunden werden als vom Hersteller vorgegeben. However, within the experiment it turned out that by chance a very good parameter set could be found, Run 11, which led to a significantly better quality of the filament. Recycled filament is not yet suitable for high-quality use with this method - further research is necessary.



Helmut-Schmidt-Universitat Universitat der Bundeswehr Hamburg


Three Dimensional Printing