High-temperature and high strain rates uniaxial tension tests for thermoset based structural adhesive Henkel Teroson EP5089

Published: 10 December 2021| Version 1 | DOI: 10.17632/rrcbysz6b9.1
Contributor:
AKSHAT AGHA

Description

The attached data contains the stress-strain curves obtained by the uniaxial tension test performed on Henkel Teroson EP5089. The tests were performed at a range of temperature (20C to 120C) and varying strain rates (SR0.0001 to SR0.1).

Files

Steps to reproduce

The tests were performed on the attached custom geometry. The samples were cured and sheared into the dogbone specimens using a special die. The tests were performed on an Instron load frame with the custom grips inside a furnace, and the strains were measured optically using a GOM Aramis 3D DIC system.

Institutions

Clemson University Department for Automotive Engineering

Categories

Adhesive Bonding, Adhesive Property, Mechanical Joint, Bonded Joint, Temperature Effect, Experimental Strain Analysis, Mechanical Design

Licence