Materials Letters

rheological data of polymer solution and drilling fluid

Detailed data of this manuscript.

This folder contains all the raw data for this paper

DC electrical conductivity GnP nanoplatelets composite materials

The data shown in the file "XRD-Zn-1Al-After immersion in SBF" is the XRD data of the porous Zn-1Al alloy scaffold after immersion in SBF.

Data：Differential scanning calorimetry (DSC)，Dynamic thermomenchanical analysis (DMA)，Static tensile test， Thermomechanical analysis (TMA)

In-situ TEM observation of both single-stage B2−B19′ transformation and two-stage B2−R−B19′ transformation in different regions

XRD patterns of synthesized products at different times and temperatures: (a) 140°C, (b) 160°C and (c) 180°C; Linear relationship between TOC removal rate and SSA (and the ratio of peak intensity in XRD patterns with the background correction: (310)/(211))

The data are the results of compressive tests on the uniform and functionally graded aluminum foams and foam-filled tubes.

The crystalline phases of the samples were analyzed by using an X-ray diffraction (XRD, Bruker D8 X-ray diffractometer) with Cu Ka radiation source. Scanning electron microscopy images (SEM) and elemental mapping were recorded on a Hitachi S-4800 instrument. Transmission electron microscopy (TEM) was performed with a JEM-2100F. The FT-IR was performed on Perkin Elmer Spectrum 100. The Brunauer-Emmett-Teller (BET) surface area and Barrett-Joiner-Halenda (BJH) pore-size distribution measurements were tested on a NOVA-2000 volumetric gas sorption instrument. UV-vis spectra of the samples were obtained using a Shimadzu UV-2550 spectrophotometer using BaSO4 as reference. Photoluminescence (PL) spectra were measured with a Fluorolog 3 spectrofluorometer (Horiba Jobin Yvon) with an excitation of 325 nm wavelength. Photodegradation process: The photocatalytic activity was evaluated under simulated solar irradiation with Rh B as a model pollutant. Briefly, 10 mg of catalyst was dispersed in Rh B solution (80 mL, 10 mg/L). Prior to irradiation, the suspension was magnetically stirred for 60 min in the dark to establish an adsorption-desorption equilibrium. A 300 W Xe lamp with simulate solar light filter was used as the light source. At given intervals, 5 mL of the suspension was withdrawn and centrifuged to remove the dispersed catalyst powder. The concentration of the clean transparent solution was determined by measuring the 553 nm absorbance of Rh B using a UV-vis spectrophotometer.