Waste Management

Data collected in PFAS diffusion tests

Fig. 4 Reactor data

We uplod the test original data which relative to our manuscript including SEM, TGA, FT-IR, BET and DFT, electric data of NPF-ACMs.

Matlab file for estimating landfill gas emissions.

Thermogravimetric analysis (TGA) of pequi seeds was performed by heating the sample from room temperature to 1000 °C, under 5, 10 and 20 °C min-1 heating rates. Data for the temperature for a certain degree of conversion (5, 15, 30, 45, 60, 75, 90%) are provided.

Three solid phase adsorption tar samples for each test condition are taken in 2 minutes intervals. Average values of the three samples are taken into consideration within the manuscript. Benzene and Toluene are considered as permanent gases and thus their are not taken into account when calculating the total amount of tar.

In these datasets, the odor concentration and concentration levels of volatiles compounds are provided for gas samples collected through different stages of digestate composting. The OAV calculated from concentrations are also presented

Including "training_data" and "testing_data", both of them have 225 cols, which has 224 reflectivity in bands range 900 to 1700nm and the last cols represent the tabel of corresponding row. In the data sets, label"1" is represent wood, label "2" is represent "plastic", label "3" is represent "brick", label "4" is represent "concrete", label 5 is represent "black brick", and label "7" is represent rubber. There is no label "6" because the rubber is special because it's color, I want rubber as the final label. So the "6" is reserved.

This spreadsheet contains a techno-economic and life cycle assessment of the anaerobic digestion of combinations of biomass (corn stover, rye, and wheat), beef cattle manure, and glycerin to produce renewable electricity and heat.

Fungal and bacterial species and potential airway deposition - waste collection plant Contributors: Anne Mette Madsen, Margit W. Frederiksen, Iman Mahmoud Kurdi, Sussi Sommer, Elisabeth Flensmark, and Kira Tendal Date: 31/1 2019 Description: Microorganisms are sampled using an Andersen six stage sampler, and are cultivated on Nutrient agar and DG-18 and following identified using MALDI-TOF MS. Data are presented as species found in each of the 6 size fractions of the Andersen sampler. The microorganisms have been sampled on a waste plant receiving cardboard waste. The sampling was performed before or during unloading of the cardboard waste.